I would recommend talking to repair shops that cater to Corvettes. The hardtop is made out of sheet molding compound, which has release compound mixed into the resin. Normal fiberglass repair techniques will not work well. All that said, I reinforced a cracked part of my hardtop with JB Marine Weld as I believe boats are also often SMC, and itRepeat steps 5-8 for the other side. 10. Carefully remove the top from the car, borrow a friend or neighbor to make this step easier. 11. Now would be a good time to do some vacuuming. 12. Carefully put the new top in, make sure the seal to the back of the car is underneath the hinge that bolts to the side of the car. After that, you remove the stopper (like corks attached to the bottom of the window. Once that is done, you simple pull the window out. Then you remove the middle regulator guide screws (I want to say 4 total, two at the top and bottom of the door). Then you remove the 3 holding the motor in. Then you do some gymnastics and pull the regulator out. any need to remove or reinstall the front seats. Do not drive with damaged front seats: Driving with damaged front seats is dangerous. A collision, even one not strong enough to inflate the air bags, could damage the front seats which contain essential air bag components. If there was a subsequent collision, an air bag may not deploy which
There is no way to reduce weight in an appreciable way without some real effort. The Miata does not have much excess fat. In my car I've removed the soft top, spare, and jack. This adds up to easily over 60lbs. The difference was very noticeable. Other people often remove the P/S, A/C, etc.
Step 3: Tape the window to the piece of Lexan. Trace the outline of the window onto the Lexan, making sure to add 1/4″-1/2″ or so to the outside edge. This outside edge will be the surface that is glued to the rear panel on top of the old window frame. Step 4: Cut out the Lexan window. I used a jigsaw with a fine blade.In this video i will be removing the old nasty soft top. It is really easy, just the screws across the front and under each side seal rubber. And the nuts al
Very nice. My NC came with a removable hardtop (before I really knew they were rare) and I enjoyed it. (Now, I prefer hitting the button on my RF nowadays after years of taking the NC hardtop down the hill to the back of my townhouse, in the back door, and carefully hanging it on the wall, but still- it was a fun hardtop.)
A bit of rubbing alcohol to remove any oils seemed like the right choice. Amazingly, there was very little black stuff on my white microfiber after I finished cleaning. I guess the bottom side of a hardtop stays clean pretty easily.A New Miata Hardtop in New York. Recent news from Mazda indicates a new 2022 Mazda MX-5 Miata hardtop. It is still very affordable, the only such car in its class, along with a convertible top. You can view the article here. This hardtop convertible was in the 2022 Editor’s Choice of the Car and Driver magazine.DJLN.